[PATCH V2 1/2] ARM: tegra: Add pinmux board file for Cardhu

[Olof Johansson]

On Sun, Feb 26, 2012 at 1:51 PM, Olof Johansson <olof at lixom.net> wrote:
> On Wed, Feb 01, 2012 at 04:29:56PM -0700, Stephen Warren wrote:
>> For now, this just sets up the pinmux and GPIOs required for the SD
>> card slot.
>>
>> Signed-off-by: Stephen Warren <swarren at nvidia.com>
>> ---
>> v2:
>> * Set PULL_UP for CMD and DATA pins on SD interface
>> * Add power GPIO for SDMMC1
>> * Add pinmux configuration for SDMMC4
>>
>> This will hopefully be replaced by the pinmux DT binding in the near
>> future, but until that happens, Tegra30 pinmux functionality needs to
>> be exposed somehow to unblock getting drivers tested on Tegra30.
>
> Thanks, applied to for-3.4/boards.

...and I'm two for two on sending the apply email before I have
checked dependencies.

This doesn't build, so I dropped it again. Probably a missing
dependency on pinctrl changes but please revisit on top of just the
tegra code and let me know.


-Olof