[PATCH V2 1/2] ARM: tegra: Add pinmux board file for Cardhu

[Olof Johansson]

On Wed, Feb 01, 2012 at 04:29:56PM -0700, Stephen Warren wrote:
> For now, this just sets up the pinmux and GPIOs required for the SD
> card slot.
> 
> Signed-off-by: Stephen Warren <swarren at nvidia.com>
> ---
> v2:
> * Set PULL_UP for CMD and DATA pins on SD interface
> * Add power GPIO for SDMMC1
> * Add pinmux configuration for SDMMC4
> 
> This will hopefully be replaced by the pinmux DT binding in the near
> future, but until that happens, Tegra30 pinmux functionality needs to
> be exposed somehow to unblock getting drivers tested on Tegra30.

Thanks, applied to for-3.4/boards.


-Olof