[PATCH V2 1/2] ARM: tegra: Add pinmux board file for Cardhu

[Stephen Warren]

Olof Johansson wrote at Sunday, February 26, 2012 3:14 PM:
> On Sun, Feb 26, 2012 at 1:51 PM, Olof Johansson <olof at lixom.net> wrote:
> > On Wed, Feb 01, 2012 at 04:29:56PM -0700, Stephen Warren wrote:
> >> For now, this just sets up the pinmux and GPIOs required for the SD
> >> card slot.
> >>
> >> Signed-off-by: Stephen Warren <swarren at nvidia.com>
> >> ---
> >> v2:
> >> * Set PULL_UP for CMD and DATA pins on SD interface
> >> * Add power GPIO for SDMMC1
> >> * Add pinmux configuration for SDMMC4
> >>
> >> This will hopefully be replaced by the pinmux DT binding in the near
> >> future, but until that happens, Tegra30 pinmux functionality needs to
> >> be exposed somehow to unblock getting drivers tested on Tegra30.
> >
> > Thanks, applied to for-3.4/boards.
> 
> ...and I'm two for two on sending the apply email before I have
> checked dependencies.
> 
> This doesn't build, so I dropped it again. Probably a missing
> dependency on pinctrl changes but please revisit on top of just the
> tegra code and let me know.

Yes, that's expected. I should have mentioned that this patch depends on
changes in the new series that added the new Tegra pinctrl driver, but
that hasn't been applied to the Tegra branches since I need to rework the
Tegra board files for changes in the pinctrl API etc. I'll repost patches
once all the pinctrl rework is finalized.

-- 
nvpublic