[PATCH v2 08/22] e1000: Consolidate register offset fixups
Andrey Smirnov
andrew.smirnov at gmail.com
Wed Jun 1 21:58:37 PDT 2016
Consolidate all code taking care on CSR offset differences for i210
chips into a single place in the driver and integrate that funcionality
into e1000_{read,write}_reg functions. This way we can get rid of all
those
if (hw->mac_type == e1000_igb) {
....
} else {
....
}
snippets sprinkled all across the driver code.
Signed-off-by: Andrey Smirnov <andrew.smirnov at gmail.com>
---
drivers/net/e1000/e1000.h | 11 ++++++++---
drivers/net/e1000/eeprom.c | 10 +++-------
drivers/net/e1000/main.c | 17 +++++------------
drivers/net/e1000/regio.c | 25 +++++++++++++++++++++++++
4 files changed, 41 insertions(+), 22 deletions(-)
diff --git a/drivers/net/e1000/e1000.h b/drivers/net/e1000/e1000.h
index d75c707..1d0b3c6 100644
--- a/drivers/net/e1000/e1000.h
+++ b/drivers/net/e1000/e1000.h
@@ -389,6 +389,11 @@ struct e1000_tx_desc {
#define E1000_MC_TBL_SIZE 128 /* Multicast Filter Table (4096 bits) */
#define E1000_VLAN_FILTER_TBL_SIZE 128 /* VLAN Filter Table (4096 bits) */
+#define E1000_MIGHT_BE_REMAPPED 0x80000000 /* Flag indicating that on
+ some variants of the chip
+ register offset might be
+ different */
+
/* Register Set. (82543, 82544)
*
* Registers are defined to be 32 bits and should be accessed as 32 bit values.
@@ -429,17 +434,17 @@ struct e1000_tx_desc {
#define E1000_LEDCTL 0x00E00 /* LED Control - RW */
#define E1000_EXTCNF_CTRL 0x00F00 /* Extended Configuration Control */
#define E1000_EXTCNF_SIZE 0x00F08 /* Extended Configuration Size */
-#define E1000_PHY_CTRL 0x00F10 /* PHY Control Register in CSR */
+#define E1000_PHY_CTRL (E1000_MIGHT_BE_REMAPPED | 0x00F10) /* PHY Control Register in CSR */
#define E1000_I210_PHY_CTRL 0x00E14 /* PHY Control Register in CSR */
#define FEXTNVM_SW_CONFIG 0x0001
#define E1000_PBA 0x01000 /* Packet Buffer Allocation - RW */
#define E1000_PBS 0x01008 /* Packet Buffer Size */
-#define E1000_EEMNGCTL 0x01010 /* MNG EEprom Control */
+#define E1000_EEMNGCTL (E1000_MIGHT_BE_REMAPPED | 0x01010) /* MNG EEprom Control */
#define E1000_I210_EEMNGCTL 0x12030 /* MNG EEprom Control */
#define E1000_FLASH_UPDATES 1000
#define E1000_EEARBC 0x01024 /* EEPROM Auto Read Bus Control */
#define E1000_FLASHT 0x01028 /* FLASH Timer Register */
-#define E1000_EEWR 0x0102C /* EEPROM Write Register - RW */
+#define E1000_EEWR (E1000_MIGHT_BE_REMAPPED | 0x0102C) /* EEPROM Write Register - RW */
#define E1000_I210_EEWR 0x12018 /* EEPROM Write Register - RW */
#define E1000_FLSWCTL 0x01030 /* FLASH control register */
#define E1000_FLSWDATA 0x01034 /* FLASH data register */
diff --git a/drivers/net/e1000/eeprom.c b/drivers/net/e1000/eeprom.c
index 497fb7b..c2dfad5 100644
--- a/drivers/net/e1000/eeprom.c
+++ b/drivers/net/e1000/eeprom.c
@@ -451,14 +451,10 @@ static int32_t e1000_poll_eerd_eewr_done(struct e1000_hw *hw, int eerd)
int32_t done = E1000_ERR_EEPROM;
for (i = 0; i < attempts; i++) {
- if (eerd == E1000_EEPROM_POLL_READ) {
+ if (eerd == E1000_EEPROM_POLL_READ)
reg = e1000_read_reg(hw, E1000_EERD);
- } else {
- if (hw->mac_type == e1000_igb)
- reg = e1000_read_reg(hw, E1000_I210_EEWR);
- else
- reg = e1000_read_reg(hw, E1000_EEWR);
- }
+ else
+ reg = e1000_read_reg(hw, E1000_EEWR);
if (reg & E1000_EEPROM_RW_REG_DONE) {
done = E1000_SUCCESS;
diff --git a/drivers/net/e1000/main.c b/drivers/net/e1000/main.c
index f1055ea..4a527a3 100644
--- a/drivers/net/e1000/main.c
+++ b/drivers/net/e1000/main.c
@@ -1184,14 +1184,11 @@ static int32_t e1000_set_d0_lplu_state_off(struct e1000_hw *hw)
if (hw->mac_type <= e1000_82547_rev_2)
return E1000_SUCCESS;
- if (hw->mac_type == e1000_ich8lan) {
+ if (hw->mac_type == e1000_ich8lan ||
+ hw->mac_type == e1000_igb) {
phy_ctrl = e1000_read_reg(hw, E1000_PHY_CTRL);
phy_ctrl &= ~E1000_PHY_CTRL_D0A_LPLU;
e1000_write_reg(hw, E1000_PHY_CTRL, phy_ctrl);
- } else if (hw->mac_type == e1000_igb) {
- phy_ctrl = e1000_read_reg(hw, E1000_I210_PHY_CTRL);
- phy_ctrl &= ~E1000_PHY_CTRL_D0A_LPLU;
- e1000_write_reg(hw, E1000_I210_PHY_CTRL, phy_ctrl);
} else {
ret_val = e1000_read_phy_reg(hw, IGP02E1000_PHY_POWER_MGMT,
&phy_data);
@@ -2745,13 +2742,9 @@ static int32_t e1000_get_phy_cfg_done(struct e1000_hw *hw)
case e1000_82572:
case e1000_igb:
while (timeout) {
- if (hw->mac_type == e1000_igb) {
- if (e1000_read_reg(hw, E1000_I210_EEMNGCTL) & cfg_mask)
- break;
- } else {
- if (e1000_read_reg(hw, E1000_EEMNGCTL) & cfg_mask)
- break;
- }
+ if (e1000_read_reg(hw, E1000_EEMNGCTL) & cfg_mask)
+ break;
+
mdelay(1);
timeout--;
}
diff --git a/drivers/net/e1000/regio.c b/drivers/net/e1000/regio.c
index 8c529f1..4970084 100644
--- a/drivers/net/e1000/regio.c
+++ b/drivers/net/e1000/regio.c
@@ -2,13 +2,38 @@
#include "e1000.h"
+static uint32_t e1000_true_offset(struct e1000_hw *hw, uint32_t reg)
+{
+ if (reg & E1000_MIGHT_BE_REMAPPED) {
+ reg &= ~E1000_MIGHT_BE_REMAPPED;
+
+ if (hw->mac_type == e1000_igb) {
+ switch (reg) {
+ case E1000_EEWR:
+ reg = E1000_I210_EEWR;
+ break;
+ case E1000_PHY_CTRL:
+ reg = E1000_I210_PHY_CTRL;
+ break;
+ case E1000_EEMNGCTL:
+ reg = E1000_I210_EEMNGCTL;
+ break;
+ }
+ };
+ }
+
+ return reg;
+}
+
void e1000_write_reg(struct e1000_hw *hw, uint32_t reg, uint32_t value)
{
+ reg = e1000_true_offset(hw, reg);
writel(value, hw->hw_addr + reg);
}
uint32_t e1000_read_reg(struct e1000_hw *hw, uint32_t reg)
{
+ reg = e1000_true_offset(hw, reg);
return readl(hw->hw_addr + reg);
}
--
2.5.5
More information about the barebox
mailing list