[PATCH] ARM: enable MMU in pbl

[Jean-Christophe PLAGNIOL-VILLARD]

On 21:56 Thu 20 Sep     , Sascha Hauer wrote:
> On Thu, Sep 20, 2012 at 08:52:43PM +0200, Jean-Christophe PLAGNIOL-VILLARD wrote:
> > On 16:30 Sun 12 Aug     , Sascha Hauer wrote:
> > > The following enables the MMU during decompression which speeds up
> > > things significantly.
> > 
> > Atmel board does not boot
> > 
> > barebox at Atmel at91sam9m10g45-ek:/ dhcp && nfs
> > /opt/work/barebox/build/sam9m10g45ek-compressed/arch/arm/pbl/zbarebox.bin &&
> > bootm zbarebox.bin
> > phy0: Link is up - 100/Full
> > DHCP client bound to address 192.168.200.43
> > 
> > Filename
> > '/opt/work/barebox/build/sam9m10g45ek-compressed/arch/arm/pbl/zbarebox.bin'.
> > 	[#################################################################]
> > 
> > without MMU boot fine
> 
> does it work with the v1 version of this patch?
work but can use nand :(

Best Regards,
J.