[PATCH] ARM: enable MMU in pbl

[Jean-Christophe PLAGNIOL-VILLARD]

On 15:23 Fri 21 Sep     , Jean-Christophe PLAGNIOL-VILLARD wrote:
> On 21:56 Thu 20 Sep     , Sascha Hauer wrote:
> > On Thu, Sep 20, 2012 at 08:52:43PM +0200, Jean-Christophe PLAGNIOL-VILLARD wrote:
> > > On 16:30 Sun 12 Aug     , Sascha Hauer wrote:
> > > > The following enables the MMU during decompression which speeds up
> > > > things significantly.
> > > 
> > > Atmel board does not boot
> > > 
> > > barebox at Atmel at91sam9m10g45-ek:/ dhcp && nfs
> > > /opt/work/barebox/build/sam9m10g45ek-compressed/arch/arm/pbl/zbarebox.bin &&
> > > bootm zbarebox.bin
> > > phy0: Link is up - 100/Full
> > > DHCP client bound to address 192.168.200.43
> > > 
> > > Filename
> > > '/opt/work/barebox/build/sam9m10g45ek-compressed/arch/arm/pbl/zbarebox.bin'.
> > > 	[#################################################################]
> > > 
> > > without MMU boot fine
> > 
> > does it work with the v1 version of this patch?
> work but can use nand :(
work but can *not* use nand :(

Best Regards,
J.