mx53 loco boot procedure

[Eric Bénard]

Hi George,

Le Tue, 21 Feb 2012 20:38:24 +0200,
George Stefan <stefan.george87 at gmail.com> a écrit :

> Hello guys,
> After  dd if=barebox.bin of=/dev/sdb bs=512 and dd if=arch/arm/boot/uImage
> of=/dev/sdb bs=512 seek=768 i am getting
> 
> Board: Freescale i.MX53 LOCO registered netconsole as cs1 eth at eth0: got MAC
> address from EEPROM: 00:04:9F:01:B4:5B mci at mci0: No partition table found
> Cannot reset the SD/MMC interface Malloc space: 0x7df00000 -> 0x7fefffff
> (size 32 MB) Stack space : 0x7def8000 -> 0x7df00000 (size 32 kB) envfs:
> wrong magic on /dev/env0 no valid environment found on /dev/env0. Using
> default environment running /env/bin/init... Hit any key to stop autoboot:
> 1 phy0: Link is up - 100/Full T DHCP client bound to address
> 128.224.168.167 TFTP from server 128.224.168.11 ('zImage-loco' -> '/image')
> 
> Wasn't the board suppose to boot from sd card by default?
> 
it will if you configure it correctly (ie: check env/config and put
the right settings inside to tell it to get the kernel from disk
instead of tftp).

Eric
-- 
http://eukrea.com/en/news/104-2012