[PATCH 4/5] ath10k: split ce irq/handler setup

[Kalle Valo]

Michal Kazior <michal.kazior at tieto.com> writes:

> On 14 August 2014 10:40, Kalle Valo <kvalo at qca.qualcomm.com> wrote:
>> Michal Kazior <michal.kazior at tieto.com> writes:
>>
>>> It doesn't make much sense to overwrite send_cb
>>> and recv_cb callbacks over and over again whenever
>>> transport starts. Just make sure to unmask copy
>>> engine interrupts when starting.
>>>
>>> Signed-off-by: Michal Kazior <michal.kazior at tieto.com>
>>
>> The patch looks, just a followup question for the future:
>>
>>> @@ -1674,7 +1639,9 @@ static int ath10k_pci_ce_init(struct ath10k *ar)
>>>               pipe_info->hif_ce_state = ar;
>>>               attr = &host_ce_config_wlan[pipe_num];
>>>
>>> -             ret = ath10k_ce_init_pipe(ar, pipe_num, attr);
>>> +             ret = ath10k_ce_init_pipe(ar, pipe_num, attr,
>>> +                                       ath10k_pci_ce_send_done,
>>> +                                       ath10k_pci_ce_recv_data);
>>
>> As we call ath10k_ce_init_pipe() only once and seem to have only one set
>> of functions, why even bother bother with function pointers? What if we
>> just call the functions directly?
>
> Yeah, we can remove this abstraction later. I don't there's anything
> depending on it anymore.

Good, again something for a rainy day :)

I added it to the TODO list (which we should cleanup as well):

http://wireless.kernel.org/en/users/Drivers/ath10k/todo

-- 
Kalle Valo