[PATCH V11 0/9] Add Invensense ICM42607

[Chris Morgan]

On Thu, Jun 11, 2026 at 11:59:38AM +0100, Jonathan Cameron wrote:
> On Wed, 10 Jun 2026 12:54:44 -0500
> Chris Morgan <macroalpha82 at gmail.com> wrote:
> 
> > From: Chris Morgan <macromorgan at hotmail.com>
> > 
> > Add support for the ICM42607 IMU. This sensor shares the same
> > functionality but a different register layout with the existing
> > ICM42600.
> > 
> > This driver should work with the ICM42607 and ICM42607P over both I2C
> > and SPI, however only the ICM42607P over I2C could be tested.
> Hi Chris,
> 
> Just a quick reminder to check if there is useful feedback at:
> https://sashiko.dev/#/patchset/20260610175455.19006-1-macroalpha82%40gmail.com
> 
> I didn't look into most of the but the last one about no avail mask bits
> being set for gyro channels was easy to verify as correct and suggests
> a testing gap.
> 
> Jonathan
> 

Thanks, I've been checking sashiko on every patch and trying to address
what it says to the best of my ability. Honestly I wish there was a way
to simply push to that bot first and *then* push to the mailing list
once I've resolved all of its comments.

Thank you,
Chris