[PATCH V11 0/9] Add Invensense ICM42607

[Jonathan Cameron]

On Wed, 10 Jun 2026 12:54:44 -0500
Chris Morgan <macroalpha82 at gmail.com> wrote:

> From: Chris Morgan <macromorgan at hotmail.com>
> 
> Add support for the ICM42607 IMU. This sensor shares the same
> functionality but a different register layout with the existing
> ICM42600.
> 
> This driver should work with the ICM42607 and ICM42607P over both I2C
> and SPI, however only the ICM42607P over I2C could be tested.
Hi Chris,

Just a quick reminder to check if there is useful feedback at:
https://sashiko.dev/#/patchset/20260610175455.19006-1-macroalpha82%40gmail.com

I didn't look into most of the but the last one about no avail mask bits
being set for gyro channels was easy to verify as correct and suggests
a testing gap.

Jonathan