[PATCH V1 4/4] arm64: dts: qcom: hamoa-iot-evk: Enable UFS

[Konrad Dybcio]

On 12/30/25 9:58 AM, Pradeep Pragallapati wrote:
> 
> On 12/29/2025 5:47 PM, Konrad Dybcio wrote:
>> On 12/29/25 7:06 AM, Pradeep P V K wrote:
>>> Enable UFS for HAMOA-IOT-EVK board.
>>>
>>> Signed-off-by: Pradeep P V K <pradeep.pragallapati at oss.qualcomm.com>
>>> ---
>> [...]
>>
>>> +&ufs_mem_hc {
>>> +    reset-gpios = <&tlmm 238 GPIO_ACTIVE_LOW>;
>>> +
>>> +    vcc-supply = <&vreg_l17b_2p5>;
>>> +    vcc-max-microamp = <1300000>;
>> I think they should both be 1.2 A peak
>>
>> Konrad
> This (1.3 A) is as per Hamoa power grid, which is same as SM8550.

Please check again, I opened the power grid tab in the internal
documentation source that shall remain nameless and it said 1200 mA
for both regulators

Konrad