[PATCH 3/4] mtd: rawnand: qcom: Make has_onfi_read_op separate from qpic_version2

[Stephan Gerhold]

QPIC v1.5 requires using the OP_PAGE_READ_ONFI_READ command, but is missing
the rest of the hardware changes that are currently covered by the QPIC v2
(qpic_version2) check in the driver. Split that into an extra
has_onfi_read_op feature flag so it can be separately enabled.

No functional change.

Signed-off-by: Stephan Gerhold <stephan.gerhold at linaro.org>
---
 drivers/mtd/nand/raw/qcom_nandc.c    | 15 ++++++++-------
 include/linux/mtd/nand-qpic-common.h |  2 ++
 2 files changed, 10 insertions(+), 7 deletions(-)

diff --git a/drivers/mtd/nand/raw/qcom_nandc.c b/drivers/mtd/nand/raw/qcom_nandc.c
index 0251dd591d40..9217e8de5512 100644
--- a/drivers/mtd/nand/raw/qcom_nandc.c
+++ b/drivers/mtd/nand/raw/qcom_nandc.c
@@ -1564,7 +1564,7 @@ static int qcom_op_cmd_mapping(struct nand_chip *chip, u8 opcode,
 		cmd = OP_FETCH_ID;
 		break;
 	case NAND_CMD_PARAM:
-		if (nandc->props->qpic_version2)
+		if (nandc->props->has_onfi_read_op)
 			cmd = OP_PAGE_READ_ONFI_READ;
 		else
 			cmd = OP_PAGE_READ;
@@ -1903,7 +1903,7 @@ static int qcom_param_page_type_exec(struct nand_chip *chip,  const struct nand_
 		nandc->regs->ecc_buf_cfg = cpu_to_le32(ECC_CFG_ECC_DISABLE);
 
 	/* configure CMD1 and VLD for ONFI param probing in QPIC v1 */
-	if (!nandc->props->qpic_version2) {
+	if (!nandc->props->has_onfi_read_op) {
 		nandc->regs->vld = cpu_to_le32((nandc->vld & ~READ_START_VLD));
 		nandc->regs->cmd1 = cpu_to_le32((nandc->cmd1 & ~READ_ADDR_MASK) |
 						FIELD_PREP(READ_ADDR_MASK, NAND_CMD_PARAM));
@@ -1911,7 +1911,7 @@ static int qcom_param_page_type_exec(struct nand_chip *chip,  const struct nand_
 
 	nandc->regs->exec = cpu_to_le32(1);
 
-	if (!nandc->props->qpic_version2) {
+	if (!nandc->props->has_onfi_read_op) {
 		nandc->regs->orig_cmd1 = cpu_to_le32(nandc->cmd1);
 		nandc->regs->orig_vld = cpu_to_le32(nandc->vld);
 	}
@@ -1925,7 +1925,7 @@ static int qcom_param_page_type_exec(struct nand_chip *chip,  const struct nand_
 	else
 		nandc_set_read_loc_first(chip, reg_base, 0, len, 1);
 
-	if (!nandc->props->qpic_version2) {
+	if (!nandc->props->has_onfi_read_op) {
 		qcom_write_reg_dma(nandc, &nandc->regs->vld, NAND_DEV_CMD_VLD, 1, 0);
 		qcom_write_reg_dma(nandc, &nandc->regs->cmd1, NAND_DEV_CMD1, 1, NAND_BAM_NEXT_SGL);
 	}
@@ -1939,7 +1939,7 @@ static int qcom_param_page_type_exec(struct nand_chip *chip,  const struct nand_
 			   nandc->buf_count, 0);
 
 	/* restore CMD1 and VLD regs */
-	if (!nandc->props->qpic_version2) {
+	if (!nandc->props->has_onfi_read_op) {
 		qcom_write_reg_dma(nandc, &nandc->regs->orig_cmd1, NAND_DEV_CMD1_RESTORE, 1, 0);
 		qcom_write_reg_dma(nandc, &nandc->regs->orig_vld, NAND_DEV_CMD_VLD_RESTORE, 1,
 				   NAND_BAM_NEXT_SGL);
@@ -2041,7 +2041,7 @@ static int qcom_nandc_setup(struct qcom_nand_controller *nandc)
 	if (!nandc->props->nandc_part_of_qpic)
 		nandc_write(nandc, SFLASHC_BURST_CFG, 0);
 
-	if (!nandc->props->qpic_version2)
+	if (!nandc->props->has_onfi_read_op)
 		nandc_write(nandc, dev_cmd_reg_addr(nandc, NAND_DEV_CMD_VLD),
 			    NAND_DEV_CMD_VLD_VAL);
 
@@ -2063,7 +2063,7 @@ static int qcom_nandc_setup(struct qcom_nand_controller *nandc)
 	}
 
 	/* save the original values of these registers */
-	if (!nandc->props->qpic_version2) {
+	if (!nandc->props->has_onfi_read_op) {
 		nandc->cmd1 = nandc_read(nandc, dev_cmd_reg_addr(nandc, NAND_DEV_CMD1));
 		nandc->vld = NAND_DEV_CMD_VLD_VAL;
 	}
@@ -2385,6 +2385,7 @@ static const struct qcom_nandc_props sdx55_nandc_props = {
 	.ecc_modes = (ECC_BCH_4BIT | ECC_BCH_8BIT),
 	.supports_bam = true,
 	.nandc_part_of_qpic = true,
+	.has_onfi_read_op = true,
 	.qpic_version2 = true,
 	.dev_cmd_reg_start = 0x7000,
 	.bam_offset = 0x30000,
diff --git a/include/linux/mtd/nand-qpic-common.h b/include/linux/mtd/nand-qpic-common.h
index 006ca8c978a9..437448995187 100644
--- a/include/linux/mtd/nand-qpic-common.h
+++ b/include/linux/mtd/nand-qpic-common.h
@@ -443,6 +443,7 @@ struct qcom_nand_controller {
  * @dev_cmd_reg_start - NAND_DEV_CMD_* registers starting offset
  * @supports_bam - whether NAND controller is using BAM
  * @nandc_part_of_qpic - whether NAND controller is part of qpic IP
+ * @has_onfi_read_op - whether ONFI param page read command is supported
  * @qpic_version2 - flag to indicate QPIC IP version 2
  * @use_codeword_fixup - whether NAND has different layout for boot partitions
  */
@@ -452,6 +453,7 @@ struct qcom_nandc_props {
 	u32 bam_offset;
 	bool supports_bam;
 	bool nandc_part_of_qpic;
+	bool has_onfi_read_op;
 	bool qpic_version2;
 	bool use_codeword_fixup;
 };

-- 
2.54.0