[PATCH] NAND: nandsim bad block injection
Vijay Kumar
vijaykumar at bravegnu.org
Wed Dec 27 10:24:17 EST 2006
Artem, here's the update patch.
Adds support for bad block creation on block erase and page program,
by returning erase/program failed in the status byte. The probability
of fault occurrence can be specified through module parameters.
Signed-off-by: Vijay Kumar <vijaykumar at bravegnu.org>
diff --git a/drivers/mtd/nand/nandsim.c b/drivers/mtd/nand/nandsim.c
index c3bca95..00b60dc 100644
--- a/drivers/mtd/nand/nandsim.c
+++ b/drivers/mtd/nand/nandsim.c
@@ -37,6 +37,8 @@
#include <linux/mtd/nand.h>
#include <linux/mtd/partitions.h>
#include <linux/delay.h>
+#include <linux/random.h>
+#include <linux/stringify.h>
/* Default simulator parameters values */
#if !defined(CONFIG_NANDSIM_FIRST_ID_BYTE) || \
@@ -70,6 +72,12 @@
#ifndef CONFIG_NANDSIM_DO_DELAYS
#define CONFIG_NANDSIM_DO_DELAYS 0
#endif
+#ifndef CONFIG_NANDSIM_ERASE_FAIL_PROB
+#define CONFIG_NANDSIM_ERASE_FAIL_PROB 0
+#endif
+#ifndef CONFIG_NANDSIM_PROG_FAIL_PROB
+#define CONFIG_NANDSIM_PROG_FAIL_PROB 0
+#endif
#ifndef CONFIG_NANDSIM_LOG
#define CONFIG_NANDSIM_LOG 0
#endif
@@ -77,6 +85,9 @@
#define CONFIG_NANDSIM_DBG 0
#endif
+#define PROB_SCALE_FACTOR 1000
+#define PROB_SCALE_FACTOR_STR __stringify(PROB_SCALE_FACTOR)
+
static uint first_id_byte = CONFIG_NANDSIM_FIRST_ID_BYTE;
static uint second_id_byte = CONFIG_NANDSIM_SECOND_ID_BYTE;
static uint third_id_byte = CONFIG_NANDSIM_THIRD_ID_BYTE;
@@ -88,6 +99,8 @@ static uint output_cycle = CONFIG_NAND
static uint input_cycle = CONFIG_NANDSIM_INPUT_CYCLE;
static uint bus_width = CONFIG_NANDSIM_BUS_WIDTH;
static uint do_delays = CONFIG_NANDSIM_DO_DELAYS;
+static uint erase_fail_prob = CONFIG_NANDSIM_ERASE_FAIL_PROB;
+static uint prog_fail_prob = CONFIG_NANDSIM_PROG_FAIL_PROB;
static uint log = CONFIG_NANDSIM_LOG;
static uint dbg = CONFIG_NANDSIM_DBG;
@@ -102,6 +115,8 @@ module_param(output_cycle, uint, 0400)
module_param(input_cycle, uint, 0400);
module_param(bus_width, uint, 0400);
module_param(do_delays, uint, 0400);
+module_param(erase_fail_prob, uint, 0400);
+module_param(prog_fail_prob, uint, 0400);
module_param(log, uint, 0400);
module_param(dbg, uint, 0400);
@@ -116,6 +131,8 @@ MODULE_PARM_DESC(output_cycle, "Word o
MODULE_PARM_DESC(input_cycle, "Word input (to flash) time (nanodeconds)");
MODULE_PARM_DESC(bus_width, "Chip's bus width (8- or 16-bit)");
MODULE_PARM_DESC(do_delays, "Simulate NAND delays using busy-waits if not zero");
+MODULE_PARM_DESC(erase_fail_prob, "Probability (scaled by " PROB_SCALE_FACTOR_STR ") of erase failing, default 0");
+MODULE_PARM_DESC(prog_fail_prob, "Probability (scaled by " PROB_SCALE_FACTOR_STR ") of program failing, default 0");
MODULE_PARM_DESC(log, "Perform logging if not zero");
MODULE_PARM_DESC(dbg, "Output debug information if not zero");
@@ -875,6 +892,32 @@ static int prog_page(struct nandsim *ns,
}
/*
+ * The function determines whether erase failure has to be
+ * injected.
+ *
+ * RETURNS: 1 if fault should be injected, 0 if fault should not be
+ * injected.
+ */
+static inline int inject_erase_fault(void)
+{
+ int rnd = random32() % PROB_SCALE_FACTOR;
+ return rnd < erase_fail_prob;
+}
+
+/*
+ * The function determines whether prog failure has to be
+ * injected.
+ *
+ * RETURNS: 1 if fault should be injected, 0 if fault should not be
+ * injected.
+ */
+static inline int inject_prog_fault(void)
+{
+ int rnd = random32() % PROB_SCALE_FACTOR;
+ return rnd < prog_fail_prob;
+}
+
+/*
* If state has any action bit, perform this action.
*
* RETURNS: 0 if success, -1 if error.
@@ -948,6 +991,16 @@ static int do_state_action(struct nandsi
erase_sector(ns);
+ /*
+ * Injecting fault after erasing the sector, saves
+ * memory since the memory used by the bad block is
+ * freed.
+ */
+ if (inject_erase_fault()) {
+ NS_DBG("do_state_action: injecting erase fault\n");
+ return -1;
+ }
+
NS_MDELAY(erase_delay);
break;
@@ -969,6 +1022,15 @@ static int do_state_action(struct nandsi
return -1;
}
+ /*
+ * Injecting fault before programming the sector,
+ * helps to save memory.
+ */
+ if (inject_prog_fault()) {
+ NS_DBG("do_state_action: injecting page prog fault\n");
+ return -1;
+ }
+
if (prog_page(ns, num) == -1)
return -1;
More information about the linux-mtd
mailing list