NAND flash question

[Artem B. Bityuckiy]

On Mon, 2005-06-27 at 14:09 -0700, Charles Tilbury wrote:
> I am using an ST Micro 64M byte x 8 bit flash part and JFFS2.  It mostly works 
> except that when the board reboots, JFFS2 reports CRC error messages when the 
> partition mounts again.  The strange part is that there does not seem to be 
> any data corruption or lost data.  Also, I do not see any error messages 
> while reading and writing.  However, the CRC errors seem to accumulate over 
> time.  Is there some way to prevent this from happening?  Repair it?  Should 
> I just ignore it?
As Sergey said, these errors appear because of unclean reboots you do.
Normally they are harmless. Yes, ignore them.

-- 
Best Regards,
Artem B. Bityuckiy,
St.-Petersburg, Russia.