NAND flash question

Charles Tilbury charles.tilbury at comcast.net
Tue Jun 28 11:58:14 EDT 2005


Yes. Thanks.  Now, I am looking for a way to get the file systems unmounted 
upon loss of power.

Thanks Guys,
-=Charles Tilbury=-

On Tuesday 28 June 2005 12:23 am, Artem B. Bityuckiy wrote:
> On Mon, 2005-06-27 at 14:09 -0700, Charles Tilbury wrote:
> > I am using an ST Micro 64M byte x 8 bit flash part and JFFS2.  It mostly
> > works except that when the board reboots, JFFS2 reports CRC error
> > messages when the partition mounts again.  The strange part is that there
> > does not seem to be any data corruption or lost data.  Also, I do not see
> > any error messages while reading and writing.  However, the CRC errors
> > seem to accumulate over time.  Is there some way to prevent this from
> > happening?  Repair it?  Should I just ignore it?
>
> As Sergey said, these errors appear because of unclean reboots you do.
> Normally they are harmless. Yes, ignore them.




More information about the linux-mtd mailing list