[PATCH 08/23] arm64: zynqmp: Add resets property to sdhci nodes

[Michal Simek]

From: Sai Krishna Potthuri <lakshmi.sai.krishna.potthuri at xilinx.com>

Add "resets" property to sdhci nodes. Resets property is used to reset the
SD host controller when dynamic configuration support is enabled.

Signed-off-by: Sai Krishna Potthuri <lakshmi.sai.krishna.potthuri at xilinx.com>
Signed-off-by: Michal Simek <michal.simek at amd.com>
---

 arch/arm64/boot/dts/xilinx/zynqmp.dtsi | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/arch/arm64/boot/dts/xilinx/zynqmp.dtsi b/arch/arm64/boot/dts/xilinx/zynqmp.dtsi
index a117294dc890..7bd3e816226a 100644
--- a/arch/arm64/boot/dts/xilinx/zynqmp.dtsi
+++ b/arch/arm64/boot/dts/xilinx/zynqmp.dtsi
@@ -755,6 +755,7 @@ sdhci0: mmc at ff160000 {
 			#clock-cells = <1>;
 			clock-output-names = "clk_out_sd0", "clk_in_sd0";
 			power-domains = <&zynqmp_firmware PD_SD_0>;
+			resets = <&zynqmp_reset ZYNQMP_RESET_SDIO0>;
 		};
 
 		sdhci1: mmc at ff170000 {
@@ -768,6 +769,7 @@ sdhci1: mmc at ff170000 {
 			#clock-cells = <1>;
 			clock-output-names = "clk_out_sd1", "clk_in_sd1";
 			power-domains = <&zynqmp_firmware PD_SD_1>;
+			resets = <&zynqmp_reset ZYNQMP_RESET_SDIO1>;
 		};
 
 		smmu: iommu at fd800000 {
-- 
2.36.1