[PATCH 08/23] arm64: zynqmp: Add resets property to sdhci nodes

[Laurent Pinchart]

Hi Michal,

Thank you for the patch.

On Tue, May 02, 2023 at 03:35:36PM +0200, Michal Simek wrote:
> From: Sai Krishna Potthuri <lakshmi.sai.krishna.potthuri at xilinx.com>
> 
> Add "resets" property to sdhci nodes. Resets property is used to reset the
> SD host controller when dynamic configuration support is enabled.
> 
> Signed-off-by: Sai Krishna Potthuri <lakshmi.sai.krishna.potthuri at xilinx.com>
> Signed-off-by: Michal Simek <michal.simek at amd.com>

Reviewed-by: Laurent Pinchart <laurent.pinchart at ideasonboard.com>

> ---
> 
>  arch/arm64/boot/dts/xilinx/zynqmp.dtsi | 2 ++
>  1 file changed, 2 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp.dtsi b/arch/arm64/boot/dts/xilinx/zynqmp.dtsi
> index a117294dc890..7bd3e816226a 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp.dtsi
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp.dtsi
> @@ -755,6 +755,7 @@ sdhci0: mmc at ff160000 {
>  			#clock-cells = <1>;
>  			clock-output-names = "clk_out_sd0", "clk_in_sd0";
>  			power-domains = <&zynqmp_firmware PD_SD_0>;
> +			resets = <&zynqmp_reset ZYNQMP_RESET_SDIO0>;
>  		};
>  
>  		sdhci1: mmc at ff170000 {
> @@ -768,6 +769,7 @@ sdhci1: mmc at ff170000 {
>  			#clock-cells = <1>;
>  			clock-output-names = "clk_out_sd1", "clk_in_sd1";
>  			power-domains = <&zynqmp_firmware PD_SD_1>;
> +			resets = <&zynqmp_reset ZYNQMP_RESET_SDIO1>;
>  		};
>  
>  		smmu: iommu at fd800000 {

-- 
Regards,

Laurent Pinchart