[PATCH 2/2] ARM: dts: kswitch-d10: enable the USB device port

[Claudiu.Beznea at microchip.com]

On 06.07.2022 11:57, Michael Walle wrote:
> EXTERNAL EMAIL: Do not click links or open attachments unless you know the
> content is safe
> 
> Hi Claudiu,
> 
> Am 2022-07-06 10:41, schrieb Claudiu.Beznea at microchip.com:
>> On 05.07.2022 16:06, Michael Walle wrote:
>>> EXTERNAL EMAIL: Do not click links or open attachments unless you know
>>> the content is safe
>>>
>>> Now that there is driver support for the USB device, enable it.
>>>
>>> Signed-off-by: Michael Walle <michael at walle.cc>
>>> ---
>>>  arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi | 5 +++++
>>>  1 file changed, 5 insertions(+)
>>>
>>> diff --git a/arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi
>>> b/arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi
>>> index 5a6c5f7c371a..d0d26e136c38 100644
>>> --- a/arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi
>>> +++ b/arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi
>>> @@ -200,6 +200,11 @@ &switch {
>>>         status = "okay";
>>>  };
>>>
>>> +&udc {
>>> +       atmel,vbus-gpio = <&gpio 66 GPIO_ACTIVE_HIGH>;
>>
>> Can you also add pinctrl to avoid issues described in:
> 
> Do I need a pinctrl node even if I just use it as a gpio?
> Isn't that handled automatically by the
> .gpio_request_enable op?

I cannot say for sure.

Looking a bit though it I think the issue described in commit I pointed may
come from the fact that struct gpio_chip::request may be
gpiochip_generic_request() which may return 0 in case
list_empty(&gc->gpiodev->pin_ranges) is true. The commit that I pointed was
introduced after commit 2ab73c6d8323 ("gpio: Support GPIO controllers
without pin-ranges") but I don't have more knowledge on it.

> 
> -michael