[PATCH 2/2] ARM: dts: kswitch-d10: enable the USB device port

[Michael Walle]

Am 2022-07-07 11:18, schrieb Claudiu.Beznea at microchip.com:
> On 06.07.2022 11:57, Michael Walle wrote:
>> EXTERNAL EMAIL: Do not click links or open attachments unless you know 
>> the
>> content is safe
>> 
>> Hi Claudiu,
>> 
>> Am 2022-07-06 10:41, schrieb Claudiu.Beznea at microchip.com:
>>> On 05.07.2022 16:06, Michael Walle wrote:
>>>> EXTERNAL EMAIL: Do not click links or open attachments unless you 
>>>> know
>>>> the content is safe
>>>> 
>>>> Now that there is driver support for the USB device, enable it.
>>>> 
>>>> Signed-off-by: Michael Walle <michael at walle.cc>
>>>> ---
>>>>  arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi | 5 +++++
>>>>  1 file changed, 5 insertions(+)
>>>> 
>>>> diff --git a/arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi
>>>> b/arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi
>>>> index 5a6c5f7c371a..d0d26e136c38 100644
>>>> --- a/arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi
>>>> +++ b/arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi
>>>> @@ -200,6 +200,11 @@ &switch {
>>>>         status = "okay";
>>>>  };
>>>> 
>>>> +&udc {
>>>> +       atmel,vbus-gpio = <&gpio 66 GPIO_ACTIVE_HIGH>;
>>> 
>>> Can you also add pinctrl to avoid issues described in:
>> 
>> Do I need a pinctrl node even if I just use it as a gpio?
>> Isn't that handled automatically by the
>> .gpio_request_enable op?
> 
> I cannot say for sure.
> 
> Looking a bit though it I think the issue described in commit I pointed 
> may
> come from the fact that struct gpio_chip::request may be
> gpiochip_generic_request() which may return 0 in case
> list_empty(&gc->gpiodev->pin_ranges) is true. The commit that I pointed 
> was
> introduced after commit 2ab73c6d8323 ("gpio: Support GPIO controllers
> without pin-ranges") but I don't have more knowledge on it.
> 

I'll just add it :) Thanks!

-michael