[PATCH] ARM: dts: vf610-zii-dev-rev-c.dts: Configure fibre port to 1000BaseX

[Chris Healy]

On Wed, Jul 8, 2020 at 11:41 AM Fabio Estevam <festevam at gmail.com> wrote:
>
> Hi Chris,
>
> In the Subject you could remove the .dts from the dts name:
>
> ARM: dts: vf610-zii-dev-rev-c: Configure fibre port to 1000BaseX
>
> On Sun, Jul 5, 2020 at 9:51 PM Chris Healy <cphealy at gmail.com> wrote:
> >
> > The SFF soldered onto the board expects the port to use 1000BaseX.  It
> > makes no sense to have the port set to SGMII, since it doesn't even
> > support that mode.
> >
> > Signed-off-by: Chris Healy <cphealy at gmail.com>
> > ---
> >  arch/arm/boot/dts/vf610-zii-dev-rev-c.dts | 2 +-
> >  1 file changed, 1 insertion(+), 1 deletion(-)
> >
> > diff --git a/arch/arm/boot/dts/vf610-zii-dev-rev-c.dts
> > b/arch/arm/boot/dts/vf610-zii-dev-rev-c.dts
> > index 778e02c000d1..de79dcfd32e6 100644
> > --- a/arch/arm/boot/dts/vf610-zii-dev-rev-c.dts
> > +++ b/arch/arm/boot/dts/vf610-zii-dev-rev-c.dts
> > @@ -164,7 +164,7 @@
> >                      port at 9 {
> >                          reg = <9>;
> >                          label = "sff2";
> > -                        phy-mode = "sgmii";
> > +                        phy-mode = "1000base-x";
>
> Looks like tabs were converted to spaces.

I'll make both changes and submit a v2, thanks.