[PATCH] ARM: dts: vf610-zii-dev-rev-c.dts: Configure fibre port to 1000BaseX

Fabio Estevam festevam at gmail.com
Wed Jul 8 14:40:54 EDT 2020


Hi Chris,

In the Subject you could remove the .dts from the dts name:

ARM: dts: vf610-zii-dev-rev-c: Configure fibre port to 1000BaseX

On Sun, Jul 5, 2020 at 9:51 PM Chris Healy <cphealy at gmail.com> wrote:
>
> The SFF soldered onto the board expects the port to use 1000BaseX.  It
> makes no sense to have the port set to SGMII, since it doesn't even
> support that mode.
>
> Signed-off-by: Chris Healy <cphealy at gmail.com>
> ---
>  arch/arm/boot/dts/vf610-zii-dev-rev-c.dts | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/arch/arm/boot/dts/vf610-zii-dev-rev-c.dts
> b/arch/arm/boot/dts/vf610-zii-dev-rev-c.dts
> index 778e02c000d1..de79dcfd32e6 100644
> --- a/arch/arm/boot/dts/vf610-zii-dev-rev-c.dts
> +++ b/arch/arm/boot/dts/vf610-zii-dev-rev-c.dts
> @@ -164,7 +164,7 @@
>                      port at 9 {
>                          reg = <9>;
>                          label = "sff2";
> -                        phy-mode = "sgmii";
> +                        phy-mode = "1000base-x";

Looks like tabs were converted to spaces.



More information about the linux-arm-kernel mailing list