[PATCH v5 2/4] Documentation: dt: add bindings for ti-cpufreq

[Rafael J. Wysocki]

On Wednesday, February 08, 2017 08:45:55 AM Dave Gerlach wrote:
> On 02/08/2017 08:44 AM, Rob Herring wrote:
> > On Fri, Feb 3, 2017 at 11:29 AM, Dave Gerlach <d-gerlach at ti.com> wrote:
> >> Add the device tree bindings document for the TI CPUFreq/OPP driver
> >> on AM33xx, AM43xx, DRA7xx, and AM57xx SoCs. The operating-points-v2
> >> binding allows us to provide an opp-supported-hw property for each OPP
> >> to define when it is available. This driver is responsible for reading
> >> and parsing registers to determine which OPPs can be selectively enabled
> >> based on the specific SoC in use by matching against the opp-supported-hw
> >> data.
> >>
> >> Acked-by: Viresh Kumar <viresh.kumar at linaro.org>
> >> Signed-off-by: Dave Gerlach <d-gerlach at ti.com>
> >> ---
> >
> > [...]
> >
> >> +/*
> >> + * cpu0 has different OPPs depending on SoC revision and some on revisions
> >> + * 0x2 and 0x4 have eFuse bits that indicate if they are available or not
> >> + */
> >> +cpu0_opp_table: opp_table {
> >
> > One step closer, but as I showed last time, use a '-', not '_'.
> 
> I apologize I thought the comment was only about the 0, completely missed the 
> underscore, you are correct, thanks.

Please send an update of this patch, then.

Thanks,
Rafael