[PATCH v5 2/4] Documentation: dt: add bindings for ti-cpufreq

[Dave Gerlach]

On 02/08/2017 08:44 AM, Rob Herring wrote:
> On Fri, Feb 3, 2017 at 11:29 AM, Dave Gerlach <d-gerlach at ti.com> wrote:
>> Add the device tree bindings document for the TI CPUFreq/OPP driver
>> on AM33xx, AM43xx, DRA7xx, and AM57xx SoCs. The operating-points-v2
>> binding allows us to provide an opp-supported-hw property for each OPP
>> to define when it is available. This driver is responsible for reading
>> and parsing registers to determine which OPPs can be selectively enabled
>> based on the specific SoC in use by matching against the opp-supported-hw
>> data.
>>
>> Acked-by: Viresh Kumar <viresh.kumar at linaro.org>
>> Signed-off-by: Dave Gerlach <d-gerlach at ti.com>
>> ---
>
> [...]
>
>> +/*
>> + * cpu0 has different OPPs depending on SoC revision and some on revisions
>> + * 0x2 and 0x4 have eFuse bits that indicate if they are available or not
>> + */
>> +cpu0_opp_table: opp_table {
>
> One step closer, but as I showed last time, use a '-', not '_'.

I apologize I thought the comment was only about the 0, completely missed the 
underscore, you are correct, thanks.

Regards,
Dave

>
> Rob
>