[PATCH 09/10] ARM: dts: Add MSHC2 dt node for SD card for exynos3250-artik5-devel board

[Chanwoo Choi]

On 2016년 03월 14일 17:31, Krzysztof Kozlowski wrote:
> On 14.03.2016 11:04, Chanwoo Choi wrote:
>> From: Jaehoon Chung <jh80.chung at samsung.com>
>>
>> This patch adds MSHC (Mobile Storage Host Controller) dt node for
>> Exynos3250 SoC. MSHC is an interface between the system and the SD card
>>
>> Signed-off-by: Jaehoon Chung <jh80.chung at samsung.com>
>> Signed-off-by: Chanwoo Choi <cw00.choi at samsung.com>
>> ---
>>  arch/arm/boot/dts/exynos3250-artik5-devel.dts | 16 ++++++++++++++++
>>  1 file changed, 16 insertions(+)
>>
>> diff --git a/arch/arm/boot/dts/exynos3250-artik5-devel.dts b/arch/arm/boot/dts/exynos3250-artik5-devel.dts
>> index d17c28969118..a371baf8536d 100644
>> --- a/arch/arm/boot/dts/exynos3250-artik5-devel.dts
>> +++ b/arch/arm/boot/dts/exynos3250-artik5-devel.dts
>> @@ -21,6 +21,22 @@
>>  			"samsung,exynos3250", "samsung,exynos3";
>>  };
>>  
>> +&mshc_2 {
>> +	num-slots = <1>;
>> +	cap-sd-highspeed;
>> +	disable-wp;
>> +	card-detect-delay = <200>;
>> +	clock-frequency = <100000000>;
>> +	clock-freq-min-max = <400000 100000000>;
>> +	samsung,dw-mshc-ciu-div = <1>;
>> +	samsung,dw-mshc-sdr-timing = <0 1>;
>> +	samsung,dw-mshc-ddr-timing = <1 2>;
>> +	pinctrl-names = "default";
>> +	pinctrl-0 = <&sd2_cmd &sd2_clk &sd2_cd &sd2_bus1 &sd2_bus4>;
>> +	bus-width = <4>;
>> +	status = "okay";
> 
> vqmmc-supply = ldo3?

ldo3 is always on state because ldo3 is used for various IP in exynos3250.
I think that we had better to remain always on state for ldo3.

Best Regards,
Chanwoo Choi