[PATCH 09/10] ARM: dts: Add MSHC2 dt node for SD card for exynos3250-artik5-devel board

[Krzysztof Kozlowski]

On 14.03.2016 11:04, Chanwoo Choi wrote:
> From: Jaehoon Chung <jh80.chung at samsung.com>
> 
> This patch adds MSHC (Mobile Storage Host Controller) dt node for
> Exynos3250 SoC. MSHC is an interface between the system and the SD card
> 
> Signed-off-by: Jaehoon Chung <jh80.chung at samsung.com>
> Signed-off-by: Chanwoo Choi <cw00.choi at samsung.com>
> ---
>  arch/arm/boot/dts/exynos3250-artik5-devel.dts | 16 ++++++++++++++++
>  1 file changed, 16 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/exynos3250-artik5-devel.dts b/arch/arm/boot/dts/exynos3250-artik5-devel.dts
> index d17c28969118..a371baf8536d 100644
> --- a/arch/arm/boot/dts/exynos3250-artik5-devel.dts
> +++ b/arch/arm/boot/dts/exynos3250-artik5-devel.dts
> @@ -21,6 +21,22 @@
>  			"samsung,exynos3250", "samsung,exynos3";
>  };
>  
> +&mshc_2 {
> +	num-slots = <1>;
> +	cap-sd-highspeed;
> +	disable-wp;
> +	card-detect-delay = <200>;
> +	clock-frequency = <100000000>;
> +	clock-freq-min-max = <400000 100000000>;
> +	samsung,dw-mshc-ciu-div = <1>;
> +	samsung,dw-mshc-sdr-timing = <0 1>;
> +	samsung,dw-mshc-ddr-timing = <1 2>;
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&sd2_cmd &sd2_clk &sd2_cd &sd2_bus1 &sd2_bus4>;
> +	bus-width = <4>;
> +	status = "okay";

vqmmc-supply = ldo3?

Best regards,
Krzysztof

> +};
> +
>  &serial_2 {
>  	status = "okay";
>  };
>