[PATCH 09/10] ARM: dts: Add MSHC2 dt node for SD card for exynos3250-artik5-devel board

[Krzysztof Kozlowski]

On 14.03.2016 17:48, Chanwoo Choi wrote:
> On 2016년 03월 14일 17:31, Krzysztof Kozlowski wrote:
>> On 14.03.2016 11:04, Chanwoo Choi wrote:
>>> From: Jaehoon Chung <jh80.chung at samsung.com>
>>>
>>> This patch adds MSHC (Mobile Storage Host Controller) dt node for
>>> Exynos3250 SoC. MSHC is an interface between the system and the SD card
>>>
>>> Signed-off-by: Jaehoon Chung <jh80.chung at samsung.com>
>>> Signed-off-by: Chanwoo Choi <cw00.choi at samsung.com>
>>> ---
>>>  arch/arm/boot/dts/exynos3250-artik5-devel.dts | 16 ++++++++++++++++
>>>  1 file changed, 16 insertions(+)
>>>
>>> diff --git a/arch/arm/boot/dts/exynos3250-artik5-devel.dts b/arch/arm/boot/dts/exynos3250-artik5-devel.dts
>>> index d17c28969118..a371baf8536d 100644
>>> --- a/arch/arm/boot/dts/exynos3250-artik5-devel.dts
>>> +++ b/arch/arm/boot/dts/exynos3250-artik5-devel.dts
>>> @@ -21,6 +21,22 @@
>>>  			"samsung,exynos3250", "samsung,exynos3";
>>>  };
>>>  
>>> +&mshc_2 {
>>> +	num-slots = <1>;
>>> +	cap-sd-highspeed;
>>> +	disable-wp;
>>> +	card-detect-delay = <200>;
>>> +	clock-frequency = <100000000>;
>>> +	clock-freq-min-max = <400000 100000000>;
>>> +	samsung,dw-mshc-ciu-div = <1>;
>>> +	samsung,dw-mshc-sdr-timing = <0 1>;
>>> +	samsung,dw-mshc-ddr-timing = <1 2>;
>>> +	pinctrl-names = "default";
>>> +	pinctrl-0 = <&sd2_cmd &sd2_clk &sd2_cd &sd2_bus1 &sd2_bus4>;
>>> +	bus-width = <4>;
>>> +	status = "okay";
>>
>> vqmmc-supply = ldo3?
> 
> ldo3 is always on state because ldo3 is used for various IP in exynos3250.
> I think that we had better to remain always on state for ldo3.

Yes, I wasn't thinking about toggling ldo3 but about taking the
regulator here to model the dependencies between components.

Best regards,
Krzysztof