[PATCH V4 00/16] irqchip: crossbar: Driver fixes
jason at lakedaemon.net
Fri Jun 27 05:01:51 PDT 2014
On Thu, Jun 26, 2014 at 12:42:09AM -0700, Tony Lindgren wrote:
> * Sricharan R <r.sricharan at ti.com> [140626 00:14]:
> > This series does some cleanups, fixes for handling two interrupts
> > getting mapped twice to same crossbar and provides support for
> > hardwired IRQ and crossbar definitions.
> > On certain platforms such as DRA7, SPIs 0, 1, 2, 3, 5, 6, 10,
> > 131, 132, 133 are direct wired to hardware blocks bypassing
> > crossbar. This quirky implementation is *NOT* supposed to be the
> > expectation of crossbar hardware usage. This series adds support
> > to represent such hard-wired irqs through DT and avoid generic
> > allocation/programming of crossbar in the driver.
> > This way of supporting hard-wired irqs was a result of
> > the below discussions.
> > http://www.spinics.net/lists/arm-kernel/msg329946.html
> > Based on 3.16 rc2 mainline.
> Jason, once these patches look OK for merging, can you please
> set them up into an immutable branch so I too can merge them in?
More information about the linux-arm-kernel