[PATCH V4 00/16] irqchip: crossbar: Driver fixes

[Tony Lindgren]

* Sricharan R <r.sricharan at ti.com> [140626 00:14]:
> This series does some cleanups, fixes for handling two interrupts
> getting mapped twice to same crossbar and provides support for
> hardwired IRQ and crossbar definitions.
> 
> On certain platforms such as DRA7, SPIs 0, 1, 2, 3, 5, 6, 10,
> 131, 132, 133 are direct wired to hardware blocks bypassing
> crossbar. This quirky implementation is *NOT* supposed to be the
> expectation of crossbar hardware usage. This series adds support
> to represent such hard-wired irqs through DT and avoid generic
> allocation/programming of crossbar in the driver.
> 
> This way of supporting hard-wired irqs was a result of
> the below discussions.
> http://www.spinics.net/lists/arm-kernel/msg329946.html
> 
> Based on 3.16 rc2 mainline.

Jason, once these patches look OK for merging, can you please
set them up into an immutable branch so I too can merge them in?

The immutable branch is needed so I can eventually apply
the related .dts changes to enable the crossbar interrupts.

Regards,

Tony