[PATCH V2] ARM: STi: DT: Properly define sti-ethclk & stmmaceth for stih415/6

[Maxime Coquelin]

Hi Peter,

On 06/16/2014 11:23 AM, Peter Griffin wrote:
> This patch fixes two problems: -
>
> 1) The device tree isn't currently providing sti-ethclk which is
> required by the dwmac glue code to correctly configure the ethernet
> PHY clock speed.
>
> This means depending on what the bootloader/jtag has
> configured this clock to, and what switch/hub the board is plugged
> into you most likely will NOT successfully negotiate a ethernet link.
>
> 2) The stmmaceth clock was associated with the wrong clock. It was
> referencing the PHY clock rather than the interconnect clock which
> clocks the IP.
>
> This patch also brings us closer to not having to boot the upstream
> kernel with the clk_ignore_unused parameter.
>
> Signed-off-by: Peter Griffin <peter.griffin at linaro.org>
> ---
>   arch/arm/boot/dts/stih415.dtsi           | 8 ++++----
>   arch/arm/boot/dts/stih416.dtsi           | 8 ++++----
>   include/dt-bindings/clock/stih415-clks.h | 1 +
>   include/dt-bindings/clock/stih416-clks.h | 1 +
>   4 files changed, 10 insertions(+), 8 deletions(-)
>

...

Acked-by: Maxime Coquelin <maxime.coquelin at st.com>

Thanks for the fix!

Maxime