[PATCH 06/23] ARM: OMAP: add OMAP5 DSI muxing

[Tony Lindgren]

* Tomi Valkeinen <tomi.valkeinen at ti.com> [140429 09:33]:
> On 29/04/14 19:19, Tomi Valkeinen wrote:
> > On 29/04/14 18:05, Tony Lindgren wrote:
> > 
> >>> omap4_padconf_global is a syscon node, not pinctrl. As syscon just gives
> >>> a raw regmap to its memory area, the driver needs to know about the OMAP
> >>> control registers to use it.
> >>
> >> That would be probably best set up the same way we have already set up
> >> for example omap4_padconf_global: tisyscon at 4a1005a0. Then drivers can
> >> access it using regmap, see how drivers/regulator/pbias-regulator.c
> >> sets up the pbias regulator with regmap for MMC.
> > 
> > Right, but it means that the driver will contain platform specific code
> > for all the omap revisions it supports. Isn't that wrong?
> > 
> > I already have a patch for DSI that uses the syscon-method, and it works
> > fine. But it's quite ugly, imo, to fiddle with the OMAP control
> > registers in a driver.

Anything using the system control module registers should be a separate
driver. And it should ideally be implemeting some Linux generic framework
that the consumer driver can then use. That leaves out the need to export
custom functions.

I guess we don't have a PHY framework for displays though, so how about
just a separate minimal driver under drivers/video/omap2 that uses the
syscon?
 
> Oh, also, if I do that, I need to know both the SoC version and the DSS
> version in the driver.

Don't you get all you need in the compatible string? Something like
compatible ti,dss-phy-omap5?

Regards,

Tony