can problems on socfpga [was Re: [PATCH v2 4/6] ARM: socfpga: dts: add can0+1]

[Dinh Nguyen]

On Fri, 2014-04-25 at 21:53 +0200, ZY - pavel wrote:
> Hi!
> 
> > > Signed-off-by: Steffen Trumtrar <s.trumtrar at pengutronix.de>
> > 
> > I have had similar patch here, except that it only listed 2 interrupts
> > for each d_can controller.
> > 
> > Otherwise it looks identical.
> > 
> > Reviewed-by: Pavel Machek <pavel at denx.de>
> 
> Actually, does it work for you? Here it produces warnings during boot
> 
> c_can_platform ffc00000.d_can: invalid resource
> c_can_platform ffc00000.d_can: control memory is not used for raminit
> c_can_platform ffc00000.d_can: c_can_platform device registered
> (regs=9085c000, irq=163)
> ...
> can: controller area network core (rev 20120528 abi 9)
> NET: Registered protocol family 29
> can: raw protocol (rev 20120528)
> can: broadcast manager protocol (rev 20120528 t)
> can: netlink gateway (rev 20130117) max_hops=1
> 
> . Then can0 is correctly registered, and seems to even receive
> packets, but only when enter is pressed on serial console... which is
> kind of weird. I suspected irq problems, but same symptomps with
> "irqpoll" -- it leads to generate 2000 irqs/second, but still waits
> for enter.
> 
> [Aha, and we have just two interrupts listed, but I don't think that
> explains all the problems. Unfortunately, that particular target uses
> human for remote power switch...].
> 
> Any ideas?

CC'ing Thor Thayer. He's done the CAN testing on the SOCFPGA platform.

Dinh
> 
> Thanks,
> 									Pavel