[PATCH 0/3 v2] clk: keystone: Add common clock drivers

[Mike Turquette]

On Wed, Sep 25, 2013 at 9:13 AM, Santosh Shilimkar
<santosh.shilimkar at ti.com> wrote:
> Mike,
>
> On Thursday 29 August 2013 03:14 PM, Santosh Shilimkar wrote:
>> v2:
>> - Aligned the bindings as per the list discussion. Removed the additional
>>       parameters by usage of reg-names and additional compatible fields.
>> - Addressed all the comments from v1 on drivers.
>> - Split the series into clock drivers($subject series) and
>>       platform, dt updates. Will post that one separately.
>>
>> Special thanks to Mike and Mark for the detailed review on v1.
>>
>> Series is an attempt to add the clock drivers for Keystone SOCs
>> based on common clock framework. A PLL drivers taking care of
>> SOC PLLs and a gate control driver taking clock management for
>> the IPs. The current Keystone based SOCs don' support dynamic power
>> management usecases like DVFS, SOC ilde etc and hence most of the
>> usage is limited to enabling clocks and finding the current clock
>> rate etc.
>>
>> Based on to of Mike's dt binding series [1] and tested on Keystone2
>> EVM.
>>
>> Cc: Mike Turquette <mturquette at linaro.org>
>
> As aligned off-list, I will revise the series to remove the
> dependency with your DT bindings series which still seems to
> be under discussion.

ACK. I plan to refresh my DT bindings and make them more concise, but
I still think it is wise if you do not rely on them. As we discussed
you can switch over to those bindings at any point in the future if
you wish.

Regards,
Mike

>
> Regards,
> Santosh