[PATCH 27/38] iio: pressure-core: st: Give some indication if device probing was successful

[Getz, Robin]

On Wednesday, September 11, 2013 3:30 AM Lee Jones wrote:
> On Wed, 11 Sep 2013, Lars-Peter Clausen wrote:
> > On 09/11/2013 09:10 AM, Lee Jones wrote:
> > >On Tue, 10 Sep 2013, Jonathan Cameron wrote:
> > >>Lee Jones <lee.jones at linaro.org> wrote:
> > Silence means everything is good, a message means there is an error.
> > If every device that gets probed would spit out a message the log
> > would be scrolling forever and you wouldn't be able to see the error
> > messages.
> 
> Only if you print out every regulator, clock, GPIO pin and things of this nature.
> Key hardware blocks such as; SD, Flash, USB, Eth, HDMI, Audio, UART, GPIO and
> I2C controllers and Sensors I think deserve a one line "I'm here and working"
> message.

In many embedded systems -- there are lots and lots of IIO devices, and I'm not sure 
I would consider very many "key". It really depends on the board.

To me it's a matter of boot time. Even memcpy to msgbuf takes time.
Sometimes unnecessary time.

> I'll not fight this for too long. This is based my experience as a user. I tried to
> look at the bootlog for the sensors I'd just enabled and there was nothing. Some
> of them had probed, some hadn't and there was no clear way to distinguish
> between them without digging into sysfs.

echo "working:"
cat /sys/bus/iio/devices/*/name

isn't too much digging. If you really want to do that on your machine - do so in rc.local

for many other subsystems, it's just not that easy, and printing from the driver is necessary.

-Robin