[PATCH 3/3] at_hdmac: add FIFO configuration parameter to DMA DT binding

[Nicolas Ferre]

On 31/05/2013 11:16, Ludovic Desroches :
> On Thu, May 30, 2013 at 06:39:36PM +0200, Jean-Christophe PLAGNIOL-VILLARD wrote:
>> On 18:32 Thu 30 May     , Nicolas Ferre wrote:
>>> On 30/05/2013 18:08, ludovic.desroches at atmel.com :
>>>> From: Ludovic Desroches <ludovic.desroches at atmel.com>
>>>>
>>>> For most devices the FIFO configuration is the same i.e. when half FIFO size is
>>>> available/filled, a source/destination request is serviced. But USART devices
>>>> have to do it when there is enough space/data available to perform a single
>>>> AHB access so the ASAP configuration.
>>>>
>>>> Acked-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>
>>>> Signed-off-by: Ludovic Desroches <ludovic.desroches at atmel.com>
>>>
>>> Clear and neat: thanks Ludo.
>>
>> agreed
>>
>> can we apply this via AT91 as this depends on some cleanup I did on DT and
>> could result on some nigthmware conflict
>>
>
> In fact, I am not sure it's the best solution. I have noticed that there is a
> conflict with a patch sent by Nicolas (dmaengine: at_hdmac: extend hardware
> handshaking interface identification) which is already in Vinod's tree but
> which is not present on Jean-Christophe's cleanup tree on which I based these
> patches.
>
> Moreover this patch doesn't use macros introduced by Nicolas' patch. I may
> update it and it should go through Vinod's tree with a dependence on patch 1/3.
>
> What's your point of view?

Indeed. Another option could be to push patches 1 and 3 in dmaengine's 
tree and make the 2nd patch go through arm-soc with a dependency on 
slave-dma GIT tree (it seems it is an usual patern).

Arnd, Jean-Christophe, what do you think?

Bye,
-- 
Nicolas Ferre