[PATCH 3/3] at_hdmac: add FIFO configuration parameter to DMA DT binding
Ludovic Desroches
ludovic.desroches at atmel.com
Fri May 31 05:16:27 EDT 2013
On Thu, May 30, 2013 at 06:39:36PM +0200, Jean-Christophe PLAGNIOL-VILLARD wrote:
> On 18:32 Thu 30 May , Nicolas Ferre wrote:
> > On 30/05/2013 18:08, ludovic.desroches at atmel.com :
> > >From: Ludovic Desroches <ludovic.desroches at atmel.com>
> > >
> > >For most devices the FIFO configuration is the same i.e. when half FIFO size is
> > >available/filled, a source/destination request is serviced. But USART devices
> > >have to do it when there is enough space/data available to perform a single
> > >AHB access so the ASAP configuration.
> > >
> > >Acked-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>
> > >Signed-off-by: Ludovic Desroches <ludovic.desroches at atmel.com>
> >
> > Clear and neat: thanks Ludo.
>
> agreed
>
> can we apply this via AT91 as this depends on some cleanup I did on DT and
> could result on some nigthmware conflict
>
In fact, I am not sure it's the best solution. I have noticed that there is a
conflict with a patch sent by Nicolas (dmaengine: at_hdmac: extend hardware
handshaking interface identification) which is already in Vinod's tree but
which is not present on Jean-Christophe's cleanup tree on which I based these
patches.
Moreover this patch doesn't use macros introduced by Nicolas' patch. I may
update it and it should go through Vinod's tree with a dependence on patch 1/3.
What's your point of view?
More information about the linux-arm-kernel
mailing list