[PATCH 20/39] usb: musb: ux500: move channel number knowledge into the driver

[Lee Jones]

On Thu, 30 May 2013, Linus Walleij wrote:

> On Wed, May 29, 2013 at 7:57 PM, Felipe Balbi <balbi at ti.com> wrote:
> > On Wed, May 15, 2013 at 10:51:43AM +0100, Lee Jones wrote:
> >> For all ux500 based platforms the maximum number of end-points are used.
> >> Move this knowledge into the driver so we can relinquish the burden from
> >> platform data. This also removes quite a bit of complexity from the driver
> >> and will aid us when we come to enable the driver for Device Tree.
> >>
> >> Cc: Felipe Balbi <balbi at ti.com>
> >> Cc: linux-usb at vger.kernel.org
> >> Acked-by: Linus Walleij <linus.walleij at linaro.org>
> >> Acked-by: Fabio Baltieri <fabio.baltieri at linaro.org>
> >> Signed-off-by: Lee Jones <lee.jones at linaro.org>
> >
> > for drivers/usb/musb
> >
> > Acked-by: Felipe Balbi <balbi at ti.com>
> 
> Is that only for this patch 20/39 or also 21, 22 & 23?
> 
> Poke us if we should re-send them...

I read this as all patches in the series "for drivers/usb/musb".

-- 
Lee Jones
Linaro ST-Ericsson Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog