[PATCH 20/39] usb: musb: ux500: move channel number knowledge into the driver

[Linus Walleij]

On Wed, May 29, 2013 at 7:57 PM, Felipe Balbi <balbi at ti.com> wrote:
> On Wed, May 15, 2013 at 10:51:43AM +0100, Lee Jones wrote:
>> For all ux500 based platforms the maximum number of end-points are used.
>> Move this knowledge into the driver so we can relinquish the burden from
>> platform data. This also removes quite a bit of complexity from the driver
>> and will aid us when we come to enable the driver for Device Tree.
>>
>> Cc: Felipe Balbi <balbi at ti.com>
>> Cc: linux-usb at vger.kernel.org
>> Acked-by: Linus Walleij <linus.walleij at linaro.org>
>> Acked-by: Fabio Baltieri <fabio.baltieri at linaro.org>
>> Signed-off-by: Lee Jones <lee.jones at linaro.org>
>
> for drivers/usb/musb
>
> Acked-by: Felipe Balbi <balbi at ti.com>

Is that only for this patch 20/39 or also 21, 22 & 23?

Poke us if we should re-send them...

Yours,
Linus Walleij