[PATCH 1/2] clk: si5351: Fix msynth_recalc_rate return value when fOUT is 0.

[Marek Belisko]

When p3 is eual to 0 then result for fOUT is 0. In that case we should
return 0 not parent_rate;

This issue was causing deadlock in si5351 chip when user set_rate for
ms0->clk0 and then set_rate for ms1->clk1 (both ms sourced from plla).
After that clk1 was 0 and it wasn't possible to enable it again (try also
manually with i2cset commands). Only power cycle helps.

Signed-off-by: Marek Belisko <marek.belisko at streamunlimited.com>
---
 drivers/clk/clk-si5351.c |    2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/clk/clk-si5351.c b/drivers/clk/clk-si5351.c
index fc215ce..a8fc0f4 100644
--- a/drivers/clk/clk-si5351.c
+++ b/drivers/clk/clk-si5351.c
@@ -607,7 +607,7 @@ static unsigned long si5351_msynth_recalc_rate(struct clk_hw *hw,
 		si5351_read_parameters(hwdata->drvdata, reg, &hwdata->params);
 
 	if (hwdata->params.p3 == 0)
-		return parent_rate;
+		return 0;
 
 	/*
 	 * multisync0-5: fOUT = (128 * P3 * fIN) / (P1*P3 + P2 + 512*P3)
-- 
1.7.9.5