[PATCH 16/63] ARM: ux500: Remove superfluous 'psize' attribute from Audio platform data

[Linus Walleij]

On Fri, May 3, 2013 at 10:59 PM, Fabio Baltieri
<fabio.baltieri at linaro.org> wrote:
> Hi Linus,
> On Fri, May 03, 2013 at 10:13:22PM +0200, Linus Walleij wrote:
>> On Fri, May 3, 2013 at 4:32 PM, Lee Jones <lee.jones at linaro.org> wrote:
>>
>> > 'psize' is used to calculate the maximum DMA burst size. However it
>> > is only taken into consideration when editing the DMA channel's
>> > configuration. The Audio DMA platform data is only used to allocate
>> > a channel, not configure it. That will be done at a later date within
>> > the MSP driver.
>> >
>> > We're also removing comments which are no longer required, as
>> > 'data_width' is no longer set in any device's platform data period.
>> >
>> > Signed-off-by: Lee Jones <lee.jones at linaro.org>
>>
>> Patch applied.
>>
>> Fabio: as I know you have audio working on the ux500
>> with the mainline driver: could you confirm that this patch
>> does not disturb the audio playback and provide a
>> Tested-by?
>
> Sure, I applied just this patch and it still works fine, tested on HREF
> with speaker-test.
> I have another non-related hack on dmaengine applied though, but Lee is
> already aware of it so this is good for me:
>
> Tested-by: Fabio Baltieri <fabio.baltieri at linaro.org>

Thanks! Much appreciated!

Yours,
Linus Walleij