[PATCH 16/63] ARM: ux500: Remove superfluous 'psize' attribute from Audio platform data

[Fabio Baltieri]

Hi Linus,

On Fri, May 03, 2013 at 10:13:22PM +0200, Linus Walleij wrote:
> On Fri, May 3, 2013 at 4:32 PM, Lee Jones <lee.jones at linaro.org> wrote:
> 
> > 'psize' is used to calculate the maximum DMA burst size. However it
> > is only taken into consideration when editing the DMA channel's
> > configuration. The Audio DMA platform data is only used to allocate
> > a channel, not configure it. That will be done at a later date within
> > the MSP driver.
> >
> > We're also removing comments which are no longer required, as
> > 'data_width' is no longer set in any device's platform data period.
> >
> > Signed-off-by: Lee Jones <lee.jones at linaro.org>
> 
> Patch applied.
> 
> Fabio: as I know you have audio working on the ux500
> with the mainline driver: could you confirm that this patch
> does not disturb the audio playback and provide a
> Tested-by?

Sure, I applied just this patch and it still works fine, tested on HREF
with speaker-test.
I have another non-related hack on dmaengine applied though, but Lee is
already aware of it so this is good for me:

Tested-by: Fabio Baltieri <fabio.baltieri at linaro.org>

Thanks,
Fabio

-- 
Fabio Baltieri