RFC: Zynq Clock Controller

Jan Lübbe jlu at pengutronix.de
Wed Mar 6 06:51:21 EST 2013


Hi Sören,

On Tue, 2013-03-05 at 12:04 -0800, Sören Brinkmann wrote:
> For this reasons, I'd like to propose moving Zynq into the same
> direction. I.e. adding a clock controller with the following DT
> description (details may change but the general idea should become
> clear):
> 	clkc: clkc {
>                 #clock-cells = <1>;
>                 compatible = "xlnx,ps7-clkc";
>                 ps_clk_frequency = <33333333>;	# board x-tal
>                 # optional props
>                 gem0_emio_clk_freq = <125000000>;
>                 gem1_emio_clk_freq = <50000000>;
>                 can_mio_clk_freq_xx = <1234>; # this is possible 54 times with xx = 00..53
>         };

The clock controller should only contain properties for input frequency
(which can obviously not be calculated at run-time).

Are the gem*, can* properties inputs? If they are actually outputs, the
corresponding frequencies should be requested by the clock consumers and
not hard-coded in DT.

Please keep in mind that DT properties use dashes instead of
underscores.

Best regards,
Jan
-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |




More information about the linux-arm-kernel mailing list