[PATCH 1/5] ARM: Kirkwood: Convert NS2 to gpio-poweroff.

[Andrew Lunn]

On Wed, Jan 09, 2013 at 09:41:13AM +0100, Simon Guinot wrote:
> On Fri, Dec 28, 2012 at 03:14:10PM +0100, Andrew Lunn wrote:
> > Remove C code and add a Device Tree node in its place.
> > 
> > Signed-off-by: Andrew Lunn <andrew at lunn.ch>
> > ---
> > 
> > This is untested. I've been known to get the active hi/low the wrong
> > way around so that the board powers off as the driver loads at boot
> > time. So it would be very good to have a tested-by: sign off.
> > 
> > 
> >  arch/arm/boot/dts/kirkwood-ns2-common.dtsi |    6 ++++++
> >  arch/arm/mach-kirkwood/board-ns2.c         |   14 --------------
> >  2 files changed, 6 insertions(+), 14 deletions(-)
> 
> Tested-by: Simon Guinot <simon.guinot at sequanux.org>
> 
> Andrew, do you want me to rebase your patch on the top of the pinctrl
> conversion one ?

Hi Simon

Thanks for testing.

What will probably be best is to wait until the next -rc comes out
containing the pinctrl fixes and then rebase on top of that.

Thanks
	Andrew