[PATCH 1/5] ARM: Kirkwood: Convert NS2 to gpio-poweroff.

[Jason Cooper]

On Fri, Dec 28, 2012 at 03:14:10PM +0100, Andrew Lunn wrote:
> Remove C code and add a Device Tree node in its place.
> 
> Signed-off-by: Andrew Lunn <andrew at lunn.ch>
> ---
> 
> This is untested. I've been known to get the active hi/low the wrong
> way around so that the board powers off as the driver loads at boot
> time. So it would be very good to have a tested-by: sign off.
> 
> 
>  arch/arm/boot/dts/kirkwood-ns2-common.dtsi |    6 ++++++
>  arch/arm/mach-kirkwood/board-ns2.c         |   14 --------------
>  2 files changed, 6 insertions(+), 14 deletions(-)

Applied to mvebu/dt with a remove/remove resolution against Simon
Guinot's patch in mvebu/fixes:

  4ea931e ARM: Kirkwood: fix ns2 gpios by converting to pinctrl

thx,

Jason.