[PATCH 0/8] ARM: at91/dt: make use of periph id macros

[Richard Genoud]

2013/8/1 Boris BREZILLON <b.brezillon at overkiz.com>:
> Hello,
>
> This patch series move at91 SoCs peripheral id definitions from machine
> specific include dir to dt-bindings include dir.
> These macros are used to reference interrupts instead of peripheral numbers.
>
> This makes dt definitions cleaner and easier to debug (one can easily tell if
> the peripheral macro used to reference an interrupt line is not the good one).
>
> These macros will be used for clk definitions and references too.
>
> I am not sure 'include/dt-bindings/at91/xxx' is the best place to put these
> definitions as there are no soc specific directories in dt-bindings include
> dir right now. Maybe something like 'include/dt-bindings/soc/at91/xxx' or
> 'include/dt-bindings/peripherals/at91/xxx' would be better.
> What do you think ?
Well, I'd rather use "atmel" than "at91" because, AFAIK, this prefix
has been dropped for new atmel SoCs (sama5 for instance).

my 2 cents...

Richard.