[PATCH] ARM: ux500: Supply a DTS file for the u8540 platform
Lee Jones
lee.jones at linaro.org
Wed Apr 24 03:52:12 EDT 2013
On Tue, 23 Apr 2013, Linus Walleij wrote:
> On Thu, Apr 4, 2013 at 9:29 AM, Lee Jones <lee.jones at linaro.org> wrote:
>
> > This is a skeleton DTS file which only enables serial. Just using
> > this simple file yields a terminal when booting u8540.
> >
> > Signed-off-by: Lee Jones <lee.jones at linaro.org>
>
> Now, wait... this doesn't work.
This is very strange and not what I see in my branch.
> > +/ {
> > + model = "ST-Ericsson U8540 platform with Device Tree";
> > + compatible = "st-ericsson,u8540";
> > +
> > + memory {
> > + reg = <0x00000000 0x20000000>;
> > + };
>
> Funny whitespace. Use tabs ...
This a single tab in my branch/editor.
> > + soc-u9500 {
>
> Please rename this not just "soc"
Done.
> > + uart at 80120000 {
> > + status = "okay";
> > + };
> > +
> > + uart at 80121000 {
> > + status = "okay";
> > + };
> > +
> > + uart at 80007000 {
> > + status = "okay";
> > + };
> > + };
> > +};
>
> The whitespace looks a bit funny compared to the
> old patch, what happened here?
>
> It also has the side effect that patch 5/9 does not
> apply... By the way, since I already applied 4/9, please
> squash 5/9 into this patch to avoid problems.
It's quite common for issues to occur when patches are taken
out-of-order. As I work with topic branches, my preference would
normally be to fix issues with the patch-set as a whole until Acks are
obtained for all of the patches, then either send a pull-request or to
have all of the patches taken from the MLs in order.
> Finally, please patch arch/arm/boot/dts/Makefile
> in the obvious way so that the DTB gets compiled.
Ah yes. Good spot.
--
Lee Jones
Linaro ST-Ericsson Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog
More information about the linux-arm-kernel
mailing list