[PATCH 08/10] ARM: msm: Prepare clk_get() users in mach-msm for clock-pcom driver

[Stephen Boyd]

On 09/26/12 10:35, Pankaj Jangra wrote:
> Hi,
>
> On Fri, Sep 21, 2012 at 7:56 AM, Stephen Boyd <sboyd at codeaurora.org> wrote:
>> In the near future we'll be moving clock-pcom to a platform
>> driver, in which case these two users of clk_get() in mach-msm
>> need to be updated. Have board-trout-panel.c make the proc_comm
>> call directly so that we don't have to port this board specific
>> code to the driver right now and reorder the initcall order of
>> dma.c so that it initializes after the clock driver probes but
>> before any drivers use dma APIs.
>>
>> Signed-off-by: Stephen Boyd <sboyd at codeaurora.org>
>> ---
>>  arch/arm/mach-msm/Makefile            |  9 ++++++---
>>  arch/arm/mach-msm/board-trout-panel.c | 19 +++++++------------
>>  arch/arm/mach-msm/dma.c               |  5 ++---
>>  3 files changed, 15 insertions(+), 18 deletions(-)
>>
>> diff --git a/arch/arm/mach-msm/Makefile b/arch/arm/mach-msm/Makefile
>> index 17519fa..3dbae74 100644
>> --- a/arch/arm/mach-msm/Makefile
>> +++ b/arch/arm/mach-msm/Makefile
>> @@ -5,12 +5,15 @@ obj-$(CONFIG_DEBUG_FS) += clock-debug.o
>>  obj-$(CONFIG_MSM_VIC) += irq-vic.o
>>  obj-$(CONFIG_MSM_IOMMU) += devices-iommu.o
>>
>> -obj-$(CONFIG_ARCH_MSM7X00A) += dma.o irq.o
>> -obj-$(CONFIG_ARCH_MSM7X30) += dma.o
>> -obj-$(CONFIG_ARCH_QSD8X50) += dma.o sirc.o
>> +obj-$(CONFIG_ARCH_MSM7X00A) += irq.o
>> +obj-$(CONFIG_ARCH_QSD8X50) += sirc.o
>>
>>  obj-$(CONFIG_MSM_PROC_COMM) += proc_comm.o clock-pcom.o vreg.o
>>
>> +obj-$(CONFIG_ARCH_MSM7X00A) += dma.o
>> +obj-$(CONFIG_ARCH_MSM7X30) += dma.o
>> +obj-$(CONFIG_ARCH_QSD8X50) += dma.o
>> +
> I did not understand what is the need of this change in Makefile?

Quoted from commit text:

reorder the initcall order of
dma.c so that it initializes after the clock driver probes but
before any drivers use dma APIs.


-- 
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
hosted by The Linux Foundation