[PATCH 08/10] ARM: msm: Prepare clk_get() users in mach-msm for clock-pcom driver

[Pankaj Jangra]

Hi,

On Fri, Sep 21, 2012 at 7:56 AM, Stephen Boyd <sboyd at codeaurora.org> wrote:
> In the near future we'll be moving clock-pcom to a platform
> driver, in which case these two users of clk_get() in mach-msm
> need to be updated. Have board-trout-panel.c make the proc_comm
> call directly so that we don't have to port this board specific
> code to the driver right now and reorder the initcall order of
> dma.c so that it initializes after the clock driver probes but
> before any drivers use dma APIs.
>
> Signed-off-by: Stephen Boyd <sboyd at codeaurora.org>
> ---
>  arch/arm/mach-msm/Makefile            |  9 ++++++---
>  arch/arm/mach-msm/board-trout-panel.c | 19 +++++++------------
>  arch/arm/mach-msm/dma.c               |  5 ++---
>  3 files changed, 15 insertions(+), 18 deletions(-)
>
> diff --git a/arch/arm/mach-msm/Makefile b/arch/arm/mach-msm/Makefile
> index 17519fa..3dbae74 100644
> --- a/arch/arm/mach-msm/Makefile
> +++ b/arch/arm/mach-msm/Makefile
> @@ -5,12 +5,15 @@ obj-$(CONFIG_DEBUG_FS) += clock-debug.o
>  obj-$(CONFIG_MSM_VIC) += irq-vic.o
>  obj-$(CONFIG_MSM_IOMMU) += devices-iommu.o
>
> -obj-$(CONFIG_ARCH_MSM7X00A) += dma.o irq.o
> -obj-$(CONFIG_ARCH_MSM7X30) += dma.o
> -obj-$(CONFIG_ARCH_QSD8X50) += dma.o sirc.o
> +obj-$(CONFIG_ARCH_MSM7X00A) += irq.o
> +obj-$(CONFIG_ARCH_QSD8X50) += sirc.o
>
>  obj-$(CONFIG_MSM_PROC_COMM) += proc_comm.o clock-pcom.o vreg.o
>
> +obj-$(CONFIG_ARCH_MSM7X00A) += dma.o
> +obj-$(CONFIG_ARCH_MSM7X30) += dma.o
> +obj-$(CONFIG_ARCH_QSD8X50) += dma.o
> +
I did not understand what is the need of this change in Makefile?

--
Pankaj Jangra