[PATCH v3 0/8] i2c: at91: cleanup and dt support

[Nicolas Ferre]

On 09/12/2012 08:42 AM, ludovic.desroches at atmel.com :
> From: Ludovic Desroches <ludovic.desroches at atmel.com>
> 
> Hi,
> 
> This set of patches is based on Nikolaus at91_i2c driver.
> 
> Changes:
> v3:
>   - only put multi-drive lines in the if...else statement (suggested
>   by Warner Losh)

Hi Wolfram,

As said by Ludovic, this series goes on top of Nikolaus' one.
My Acked-by is already set on this one, so I think that I have nothing
more to do ;-)

BTW, in case you need help to sort all this, do not hesitate to contact
us... we can setup a git tree for this...

Bye,


> v2:
>   - change driver name from xxx_i2c to i2c-xxx
>   - keep i2c-gpio nodes in dtsi files
>   - don't enable TWI on boards whose TWI IP doesn't support clock
>   stretching in tranmission mode
> 
> Ludovic Desroches (8):
>   i2c: at91: use managed resources
>   i2c: at91: add warning about transmission issues for some devices
>   i2c: at91: use an id table for SoC dependent parameters
>   ARM: at91: do not configure at91sam9g10 twi pio as open-drain
>   i2c: at91: add dt support to i2c-at91
>   ARM: at91: add clocks for I2C DT entries
>   ARM: dts: add twi nodes for atmel SoCs
>   ARM: dts: add twi nodes for atmel boards
> 
>  .../devicetree/bindings/i2c/atmel-i2c.txt          |  30 +++
>  arch/arm/boot/dts/at91sam9260.dtsi                 |  10 +
>  arch/arm/boot/dts/at91sam9263.dtsi                 |  10 +
>  arch/arm/boot/dts/at91sam9g20.dtsi                 |   4 +
>  arch/arm/boot/dts/at91sam9g25ek.dts                |  12 ++
>  arch/arm/boot/dts/at91sam9g45.dtsi                 |  20 ++
>  arch/arm/boot/dts/at91sam9m10g45ek.dts             |   8 +
>  arch/arm/boot/dts/at91sam9n12.dtsi                 |  20 ++
>  arch/arm/boot/dts/at91sam9n12ek.dts                |   8 +
>  arch/arm/boot/dts/at91sam9x5.dtsi                  |  30 +++
>  arch/arm/mach-at91/at91rm9200.c                    |   2 +-
>  arch/arm/mach-at91/at91rm9200_devices.c            |  11 +-
>  arch/arm/mach-at91/at91sam9260.c                   |   4 +-
>  arch/arm/mach-at91/at91sam9260_devices.c           |   8 +-
>  arch/arm/mach-at91/at91sam9261.c                   |   3 +-
>  arch/arm/mach-at91/at91sam9261_devices.c           |  23 +--
>  arch/arm/mach-at91/at91sam9263.c                   |   3 +-
>  arch/arm/mach-at91/at91sam9263_devices.c           |   2 +-
>  arch/arm/mach-at91/at91sam9g45.c                   |   6 +-
>  arch/arm/mach-at91/at91sam9g45_devices.c           |   4 +-
>  arch/arm/mach-at91/at91sam9n12.c                   |   2 +
>  arch/arm/mach-at91/at91sam9rl.c                    |   4 +-
>  arch/arm/mach-at91/at91sam9rl_devices.c            |   2 +-
>  arch/arm/mach-at91/at91sam9x5.c                    |   6 +-
>  drivers/i2c/busses/Kconfig                         |   6 +
>  drivers/i2c/busses/i2c-at91.c                      | 217 +++++++++++++--------
>  26 files changed, 338 insertions(+), 117 deletions(-)
>  create mode 100644 Documentation/devicetree/bindings/i2c/atmel-i2c.txt
> 


-- 
Nicolas Ferre