[RFT/PATCH] serial: omap: prevent resume if device is not suspended.

[Kevin Hilman]

Sourav <sourav.poddar at ti.com> writes:

> Hi Paul,
>
> There are
> On Thursday 11 October 2012 11:58 PM, Paul Walmsley wrote:
>> Hi Sourav, Felipe,
>>
>> any progress on fixing the N800 problem?  Would be good to keep it booting
>> since we use it as our primary 2420 test platform.
>>
>>
>> - Paul
> The patch sent inlined below might help us to get rid of the serial
> init issue.
> Unfortunately, I dont have a N800 board with me to test it and will require
> your help to do so.
> -----------
> From: Sourav Poddar <sourav.poddar at ti.com>
> Date: Wed, 1 Aug 2012 15:44:12 +0530
> Subject: [RFT/PATCH] serial: omap: Fix N800 serial init issue.
>
>
> This patch might solve the N800 serial init issue.
>
> This patch will also give pointers if there is any mux settings issue
> with N800 OR
> a mismatch between the initial harware state, runtime PM state and
> omap hwmod state.

> I don't have a N800 schematics to check about the mux settings getting used.
>
> The observation on beagle board XM with this patch on different boards
> looks flaky,
> so your feedback on beagle board will also be very helpful.
>
> Cc: Felipe Balbi <balbi at ti.com>
> Signed-off-by: Sourav Poddar <sourav.poddar at ti.com>
> ---
>  drivers/tty/serial/omap-serial.c |    1 +
>  1 files changed, 1 insertions(+), 0 deletions(-)
>
> diff --git a/drivers/tty/serial/omap-serial.c
> b/drivers/tty/serial/omap-serial.c
> index 6ede6fd..3fbc7f7 100644
> --- a/drivers/tty/serial/omap-serial.c
> +++ b/drivers/tty/serial/omap-serial.c
> @@ -1414,6 +1414,7 @@ static int __devinit serial_omap_probe(struct
> platform_device *pdev)
>         INIT_WORK(&up->qos_work, serial_omap_uart_qos_work);
>
>         platform_set_drvdata(pdev, up);
> +       pm_runtime_set_active(&pdev->dev);

NAK.

This will obviously break platforms where the UARTs are not active
before driver loads.

Kevin

>         pm_runtime_enable(&pdev->dev);
>         pm_runtime_use_autosuspend(&pdev->dev);
>         pm_runtime_set_autosuspend_delay(&pdev->dev,