[RFC 00/24] OMAP serial driver flow control fixes, and preparation for DMA engine conversion

[Sourav]

Hi Kevin,
On Wednesday 10 October 2012 11:59 PM, Kevin Hilman wrote:
> Hi Sourav,
>
> Sourav <sourav.poddar at ti.com> writes:
>
> [...]
>
>> Boot Tested this patch series against v3.6 tag(applied cleanly) on
>> panda board and
>> PM tested(hitting off in Idle and suspend) on omap3630 based beagle board.
>>
>> Note, I also tested the patches against the current master but only
>> after rebasing, since the current master includes serial patches from
>> Felipe Balbi[1].
>> [1] https://lkml.org/lkml/2012/8/24/139
>>
>> Tested-by: Sourav Poddar <sourav.poddar at ti.com>
> Did you test flow control after off-mode transitons?
>
> Russell indicated that the context save/restore is not saving important
> bits related to HW flow control, so I suspect some more testing,
> specifically of flow control after off-mode is needed.
>
> Kevin
The testing done was without any flow control enabled.
I will try to figure out how to do a hardware flow control testing
and see the status after the off mode.

~Sourav